Installing The Desk Dehumidifier (Service Part) - Kyocera Mita KM-3530 Service Manual

Hide thumbs Also See for KM-3530:

Table of Contents

1-2-2 Installing the desk dehumidifier (service part)

Desk dehumidifier installation requires the following parts:

Desk dehumidifier (P/N 33960020): for 220 – 240 V specifications only

Desk dehumidifier (P/N 34860030): for 120 V specifications only

Two (2) M4 × 8 S tight screws (P/N B3324080)

1. Remove the upper and lower drawers.

2. Remove the three screws holding the desk

rear cover and then the cover.

3. Pass the desk dehumidifier cable to the

machine rear through the cable hole in the

machine right.

4. Attach the desk dehumidifier using the two M4

× 8 S tight screws.

5. Insert the desk dehumidifier connector into the

connector of the main harness.

6. Tidy up the desk dehumidifier cable using the

wire saddle and route the cable while clipping

the wire saddles into the holes in the rear

7. Refit all removed parts.

tight screws

Desk dehumidifier

Desk dehumidifier

Figure 1-2-2

Main harness

Figure 1-2-3

Table of Contents