2BH/J
1-3-14 Installing the built-in finisher (option)
Preparation
1. Remove the two screws and then remove the
upper left cover.
2. Open the conveying cover and the front
cover.
3. Loosen the two screws on the left side and
the screw on the front side, open the hook on
the right side, and remove the left front cover.
4. Close the conveying cover and the front
cover.
5. Remove the two screws and then remove the
ejection cover with the mounting plate.
1-3-50
Upper left cover
Screws
Figure 1-3-107
Left front cover
Screws
Figure 1-3-108
Ejection cover
Figure 1-3-109
Hook
Screw
Screws