Adjusting The Amount Of Slack - Kyocera Mita KM-3530 Service Manual

3CC

(5) Adjusting the amount of slack

Perform the following adjustment if the leading edge of the copy image is missing or varies randomly, or if the copy paper is
Z-folded.
Procedure
Enter maintenance mode.
Enter "051" using the numeric keys.
Press the start key.
Select "FEED DATA."
Select the drawer to be adjusted.
Press the interrupt key.
Press the start key
to make a test copy.
Is the leading edge
of the image missing or varying randomly
(copy example 1)?
Is the copy paper
Z-folded (copy example 2)?
Press the stop/clear key.
Exit maintenance mode.
1-4-8
Start
Yes
No
Yes
No
End
Original
Press the start key.
The new setting is stored.
Increase the value using
the cursor upper key.
Decrease the value using
the cursor lower key.
Setting range: 0 – 255
Changing the value by 1 changes
the amount of slack by 0.67 mm
Reference: 0
The greater the value, the larger
the amount of slack;
The smaller the value, the smaller
the amount of slack.
Copy Copy
example 1 example 2
Figure 1-4-16