Adjusting The Position Of The Rack Adjuster - Kyocera Mita KM-3530 Service Manual

(4) Adjusting the position of the rack adjuster

Perform the following adjustment if there is a regular error between the center lines of the copy image and the original on the
paper fed from the drawer.
Procedure
Enter maintenance mode.
Run maintenance item U993.
Select "VTC PG1" and output
a test pattern.
Is the image correct?
Exit maintenance mode.
Start
No
Yes
End
Figure 1-4-15 Adjusting the position of the rack adjuster
Correct image
Loosen the three screws holding
the rack adjuster and change the
position of the adjuster so that
the centers of the original and
the copy image are aligned.
• For output example 1, move
toward the machine front (
• For output example 2, move
toward the machine rear (
Screws
Rack adjuster
Output
example 1 example 2
Figure 1-4-14
).
).
3CC
Output
1-4-7