Parts Names And Their Functions; Copier; Operation Panel - Kyocera Mita KM-3530 Service Manual

3CM

1-1-2 Parts names and their functions

(1) Copier

1 Operation panel ..................................... Use the operation panel to perform the procedures required for fax
2 Fax storage section ................................ Received documents are ejected and stored face-down in the fax storage
3 Drawers .................................................. This fax machine comes standard with two drawers installed. Each drawer
4 Multi-Bypass .......................................... Paper can be set in the Multi-Bypass as well. In order to use the Multi-
5 Telephone jack (T) .................................. Use this jack to connect a separately purchased telephone to the fax.
6 Line jack (L) ........................................... Use this jack to connect the fax to a telephone line using the modular cord.
7 Main switch ............................................ Turn this switch ON ( | ) in order to perform fax and copy operations. The
• Document Processor
There are 2 optional document processors available for use with this machine: the document processors for feeding one-
sided documents, and the duplex document processor for using both sides of 2-sided documents.
* Both the document processor and duplex document processor can be used with the 25 copies per minute machine.
However, only the duplex document processor can be used with the 35 copies per minute machine.
8 Document table ...................................... Set the documents you want to transmit on this table. Up to 70 sheets of up
9 Document insert guides ......................... Adjust these guides to match the width of the documents.
10 Document processor reversing cover ..... Open this cover if a document jams.
11 Document eject cover ............................ Documents are ejected onto this cover after being scanned.
12 Eject guide ............................................. Open this guide when transmitting documents of a large size such as 8 1/2" x
13 Document processor open/close lever ... Operate this lever when opening and closing the document processor.
14 Document set indicator .......................... This indicator indicates the status of the documents set in the document
1-1-4
Figure 1-1-1
communication.
section. Up to 250 sheets can be stored in this section at one time.
can hold up to 500 sheets of plain paper (60 g/m2 - 105 g/m2).
Bypass, it is necessary to select "ON" under "Turning Manual Paper Feed
ON/OFF".
message display will light and operation will be possible.
to 11" x 8 1/2" [A4] size paper, or up to 50 sheets of 8 1/2" x 14" or 11" x 17"
[A3 or Folio] size paper, can be set at one time.
14" or 11" x 17" [A3 or Folio].
processor. Documents are set properly when the indicator is lit green.
Figure 1-1-2