Detaching And Refitting The Deck Paper Conveying Unit Assembly; Detaching And Refitting Deck Paper Feed Rollers 1 And 2 - Kyocera Mita KM-3530 Service Manual

(2) Detaching and refitting the deck paper conveying unit assembly

Replace the desk upper or lower paper width switches as follows.
Procedure
1. Open the drawer.
2. Remove the left cover.
3. Remove the two screws holding the deck
paper conveying unit assembly and then the
assembly.

(3) Detaching and refitting deck paper feed rollers 1 and 2

Clean or replace paper feed rollers 1 and 2 as follows.
Procedure
1. Turn the deck paper conveying unit over.
2. Remove the stop ring while lifting the deck
paper feed roller section.
3. Pull out the shifting shaft and then deck paper
feed rollers 1 and 2.
4. Clean or replace deck paper feed rollers 1
and 2.
5. Refit all removed parts.
Deck paper conveying
unit assembly
Screw
Figure 1-4-2 Detaching and refitting the deck paper
Shifting shafts
Deck paper
feed roller 2
Figure 1-4-3 Detaching and refitting deck paper feed rollers
Screw
conveying unit assembly
Deck paper feed roller 1
1 and 2
5FF
Stop rings
1-4-3