Contents Of Maintenance Mode Items - Kyocera Mita KM-3530 Service Manual

Hide thumbs Also See for KM-3530:

Table of Contents

(2) Contents of maintenance mode items

Initializing all data

Initializes software switches and all data in the SRAM on the fax control PCB, according to the destination and

Used to initialize the fax control PCB.

1. Press the start key. The screen for entering the destination code is displayed.

Enter a destination code using the numeric keys (refer to the destination code list on page 1-3-5 for the

destination code).

COUNTRY CODE:000

2. Press the start key. The screen for entering the OEM code is displayed.

There is no operation necessary on this screen.

OEM CODE:000

3. Press the start key. Data initialization starts. To cancel data initialization, press the stop/clear key.

4. After data initialization, the entered destination and OEM codes are displayed, and the ROM version is

displayed two seconds later.

COMPLETED 000 000

COMPLETED V1.00

If initialized with "000" (code for Japan) entered as the destination code, service call code C082 (fax control

PCB problem) will be detected. Be sure to enter the correct destination code. If C082 (fax control PCB problem)

is detected, press the COPY/FAX switching key to put the machine in the copy mode, open the front cover and

then execute this maintenance item again to enter the correct destination code and initialize data.

Table of Contents