Switch Features And Defaults - NETGEAR XS728T ProSAFE Software Administration Manual

Switch Features and Defaults

Feature
Auto negotiation/static
speed/duplex
Auto MDI/MDIX
802.3x flow control/back pressure
Port mirroring
Port trunking (aggregation)
802.1D spanning tree
802.1w RSTP
802.1s spanning tree
Static 802.1Q tagging
Learning process
Storm control per each packet
type (unicast, broadcast,
multicast)
Jumbo frame
Number of queues
Port based
802.1p
DSCP
Rate limiting
Auto-QoS
802.1x
MAC ACL
IP ACL
IPv6 ACL
XS728T ProSAFE 28-Port 10-Gigabit L2+ Smart Switch
Sets Supported
All ports
N/A
1 (per system)
1 destination port and 8 source
ports
8
1
1
16 instances
512
Supports static and dynamic MAC
entries
All ports
All ports
8
N/A
1
1
All ports
All ports
All ports
164 (shared with IP and IPv6
ACLs)
164 (shared with MAC and IPv6
ACLs)
164 (shared with IP ACL and MAC
ACL)
Hardware Specifications and Default Values
Default
Auto-negotiation
Enabled
Disabled
Disabled
Pre-configured
Disabled
Enabled
Disabled
Default VLAN ID = 1
Dynamic learning is enabled by
default
Disabled
Enabled.
Max.= 10 KB
N/A
N/A
Enabled
Disabled
Disabled
Disabled
Disabled
All MAC addresses allowed
All IP addresses allowed
All IP addresses allowed
182