Table of Contents
Advertisement
Insight Managed 28-Port and 52-Port Gigabit Ethernet (PoE+) Smart Cloud Switch
The USB storage device that you attach to the USB port must comply with the following
requirements:
• The USB device must support USB 2.0.
• The USB device must support the FAT32 or VFAT file type. The NTFS file type is not
supported.
Console Port
The switch provides one micro USB port for console access and debug purposes. Use
this port only as directed and assisted by technical support.
Multifunction Reset Button
The switch provides a recessed multifunction Reset button on the front panel so that
you can either restart the switch, reset the switch to the most recently saved
cloud-managed configuration, or return the switch to its factory default settings, causing
all custom settings to be erased. The factory default settings function of the Reset button
is available only after you use the NETGEAR Insight app to remove the switch from your
network.
To restart or reset the switch or return the switch to its factory default settings:
1. Insert a device such as a straightened paper clip into the opening.
2. Do one of the following:
• Restart the switch. Press the Reset button for about two seconds. (Do not press
the button for more than five seconds!)
The switch restarts but retains its custom settings. During this process, the Power
LED lights amber.
• Reset the switch to the most recently saved cloud-managed configuration.
Press the Reset button for at least five seconds.
The switch restarts and returns to the most recently saved cloud-managed
configuration. During this process, the Power LED lights amber.
• Return the switch to its factory default settings. After you use the NETGEAR
Insight app to remove the switch from your network, press the Reset button for
at least five seconds.
The switch restarts and returns to its factory default settings. During this process,
the Power LED lights amber.
Hardware Overview
22
Hardware Installation Guide
Advertisement
Table of Contents
