Dual Image Status; Troubleshooting - NETGEAR XS728T ProSAFE Software Administration Manual

software version is discovered by the system running an older version of the software, the
system displays an appropriate warning to the user.
Use the Dual Image Configuration screen to set the boot image, or configure an image
description.
To configure Dual Image settings:

1. Select Maintenance > File Management > Dual Image > Dual Image Configuration.
2. In the Image Name field, select one of the images from the list.
The Current-active field displays the name of the active image.
3. To configure a descriptive name for the selected software image, type the name in the
Image Description field.
The valid range is 0–160 characters.The factory default is blank.
4. To set the selected image as the active image, select the Activate Image check box.
Note: After activating an image, you must perform a system reset of the
switch to run the new code.
5. Click Apply to apply the settings to the switch.

Dual Image Status

The Dual Image Status screen displays system images.
To display Dual Image settings:

Select Maintenance > File Management > Dual Image > Dual Image Status.
The Dual Image Status screen displays the following:
• Image1 Ver. The version of the image1 code file.
• Image2 Ver. The version of the image2 code file.
• Current-active. The currently active image on this unit.
• Next-active. The image used on the next restart of this unit.
• Image1 Description. The description associated with the image1 code file.
• Image2 Description. The description associated with the image2 code file.

Troubleshooting

The Troubleshooting menu contains links that provide access to the features described in the
following sections:
• Ping IPv4
XS728T ProSAFE 28-Port 10-Gigabit L2+ Smart Switch
Maintenance
171