Route Table - NETGEAR XS728T ProSAFE Software Administration Manual

ICMP Rate Limiting, set this field to 0.The valid Rate Interval must be in the range 0 to
2147483647 micro seconds.
4. In the ICMPv6 Rate Limit Burst Size field, specify the number of ICMP error packets
allowed per burst interval. This value controls the ICMP error packets. Default burst size is
100 packets. Valid Burst Size must be in the range of 1 to 200.
5. In the IPv6 MTU field, specify in bytes the maximum Transmitted packet size for IPv6
routing. This must be in the range of 1280 to 9000. The default setting is 1500 bytes.
6. Click Apply to send the updated configuration to the switch. Configuration changes take
effect immediately.

Route Table

The Route table contains all the IPv6 routes, static and non-static that exist on the device.
To add a static IPv6 route to the Route Table:

1. Click Routing> IPv6 > Basic > Route Table.
2. Enter the following fields for the route:
• IPv6 Prefix. Enter the network prefix.
• Prefix Length. Enter the network length.
• Next Hop IPv6 Address Type. Select either Link Local or Global
• Next Hop IPv6 Address. Enter the next hop IPv6 address for the route
• Interface. Enter the outgoing IPv6 routing VLAN Interface to use when forwarding
traffic to the destination
• Preference. Enter the route preference of this route
3. Select the IPv6 Route Table to display.
4. In the Routes Displayed list, select from the following:
• All Routes. Shows all best active IPv6 routes.
• All Static Routes. Shows the static routes configured by the users.
The fields described above are displayed for the routes. In addition, the following fields
are described:
• Protocol. How route was created. The following options are available:
• Static. Manually defined.
• ND (Neighbor Discovery). Discovered by ND protocol.
• Connected. Route was derived from a manually-configured device's IPv6
address.
• Next Hop Interface. Enter the network length.
5. Click Update to update the page with the latest information on the switch.
XS728T ProSAFE 28-Port 10-Gigabit L2+ Smart Switch
.
Routing
.
94
.
.