Lldp; Snmp Supported Mibs; Snmp V3 User Configuration - NETGEAR XS728T ProSAFE Software Administration Manual

The factory default is Enable.
4. Click Apply.
Configuration changes take effect immediately.

SNMP Supported MIBs

The screen allows you to view a list of the supported MIBs.
To display the Supported MIBS screen:

Select System > SNMP > SNMP v1/v2 > Supported MIBS.

SNMP v3 User Configuration

This is the configuration for SNMP v3.
The SNMPv3 Access Mode is a read-only field that shows the access privileges for the user
account. The admin account always has read/write access, and all other accounts have
read-only access.
To configure SNMPv3 settings for the user account:

1. Select System > SNMP > SNMP v3 > User Configuration.
2. Next to Authentication Protocol, select the SNMPv3 Authentication Protocol setting for the
selected user account. The following are the valid authentication protocols:
• None. No authentication is performed
• MD5 or SHA. The user login password is used as SNMPv3 authentication password,
and you must therefore specify a password. The password must be eight characters
in length.
3. Next to Encryption Protocol, select whether to encrypt SNMPv3 packets transmitted by the
switch.
• None. Do not encrypt the contents of SNMPv3 packets transmitted from the switch.
• DES. Encrypt SNMPv3 packets using the DES encryption protocol.
4. If you selected DES for the Encryption Protocol, enter the SNMPv3 encryption key in the
Encryption Key field. Otherwise, this field is ignored. Valid keys are 0–15 characters long.
5. Click Apply.
Configuration changes take effect immediately.

LLDP

The IEEE 802.1AB-defined standard, Link Layer Discovery Protocol (LLDP), allows stations
on an 802 LAN to advertise major capabilities and physical descriptions. A network manager
views this information to identify system topology and detect bad configurations on the LAN.
XS728T ProSAFE 28-Port 10-Gigabit L2+ Smart Switch
System
32