Lldp Port Settings - NETGEAR XS728T ProSAFE Software Administration Manual

• Reinitializing Delay. Specify the delay before a reinitialization. The default is 2
seconds, and the range is 1–10 seconds.
• Transmit Delay. Specify the interval for the transmission of notifications. The default
is 5 seconds, and the range is 2–3600 seconds.
3. To change the LLDP-MED properties in the Fast Start Duration field, specify the number of
LLDP packets sent when the LLDP-MED Fast Start mechanism is initialized.
This occurs when a new endpoint device links with the LLDP-MED network connectivity
device. The default value is 3, and the range is from 1–10.
4. Click Apply.
Configuration changes take effect immediately.

LLDP Port Settings

Use the LLDP Port Settings screen to specify LLDP parameters that are applied to a specific
interface.
To configure LLDP port settings:

1. Select System > LLDP > Advanced > LLDP Port Settings.
2. Select the check box next to one or more ports.
3. Specify the following LLDP port settings:
• Interface. Specifies the port affected by these parameters.
• Admin Status. Select the status for transmitting and receiving LLDP packets:
• Tx Only. Enable only transmitting LLDP PDUs on the selected ports.
• Rx Only. Enable only receiving LLDP PDUs on the selected ports.
• Tx & Rx. Enable both transmitting and receiving LLDP PDUs on the selected
ports. This value is the default value.
• Disabled. Do not transmit or receive LLDP PDUs on the selected ports.
• Management IP Address. Select whether to advertise the management IP address
from the interface. The possible values are:
• Stop Advertise. Do not advertise the management IP address from the interface.
• Auto Advertise. Advertise the current IP address of the device as the
management IP address.
• Notification. When notifications are enabled, LLDP interacts with the trap manager to
notify subscribers of remote data change statistics. The default is Disabled.
• Optional TLVs. Enable or disable the transmission of optional type-length value (TLV)
information from the interface. The optional TLV information includes the system
name, system description, system capabilities, and port description. For information
about how to configure the system name, see
information about how to configure the port description, see
4. Click Apply to apply the new settings to the system.
XS728T ProSAFE 28-Port 10-Gigabit L2+ Smart Switch
System
Management
34
on page 16. For
Ports on page 48.