Auto Redial Setup - Fuji Xerox DocuPrint CM225FW User Manual

Remote Receive
Purpose:
To receive a fax by pressing a remote receive code on the external telephone after picking up the handset of the
telephone.
Values:
Does not receive a fax by pressing a remote receive code on the external telephone.
Off*
On
Remote Receive
Tone
Discard Size
Purpose:
To set the printer to discard images or any text at the bottom of a fax page when the entire page does not fit the
output paper.
Values:
Off
On
Auto Reduction*
• Transmission Defaults
Purpose:
To configure settings for transmitting fax.

Auto Redial Setup

Purpose:
To configure settings for automatic redial.
Values:
Number of Redial
Redial Interval
Interval Timer
1
* The default for Number of Redial varies depending on region-specific factory.
Dial Type
Purpose:
To select the dialing type.
Values:
PB*
DP(10PPS)
DP(20PPS)
NOTE:
• The dialing type that you can select differs depending on the region setting.
Receives a fax by pressing a remote receive code on the external telephone.
Specifies the tone in two digits to start Remote Receive.
Prints excess images or text at the bottom of a fax page without discarding it.
Discards any excess images or text.
Automatically reduces a fax page to fit it onto the appropriate paper size.
1
Sets the number of redial attempts to make when the destination fax number is
3*
busy. If you enter 0, the printer will not redial. The value is set in increments of 1.
0-9
Sets the interval between redial attempts. The value is set in increments of 1
1*
minute.
1-15
Sets the interval between re-send attempts. The value is set in increments of 1
8*
second.
3-255
Uses tone dialing.
Sets DP (10PPS) (Dial Pulse, 10 Pulse Per Second) as the dial type.
Sets DP (20PPS) (Dial Pulse, 20 Pulse Per Second) as the dial type.
Using the Operator Panel Menus and Keypad 225