The Output Is Too Light - Fuji Xerox DocuPrint CM225FW User Manual

 The Output Is Too Light
Problem

The output is too light.

NOTE:
• If the problem continues even though you have taken suggested actions described above, contact the Fuji Xerox local
representative office or an authorized dealer.
280 Troubleshooting
Action
The toner cartridges may be low or need to be replaced. Confirm the amount of
toner in each toner cartridge.
1 Check the toner level in the Status tab in the Printer Status window of the
SimpleMonitor.
2 Replace the toner cartridges as necessary.
Verify that the print media is dry and the correct print media is used.
If not, use the print media recommended for the printer.
See also:
• "Usable Print Media" on page 95
Try changing the paper type setting in the print driver. The following procedure
®
uses the Microsoft Windows
1 On the Paper/Output tab in Printing Preferences of the print driver, change
the Paper Type setting.
2 Load dry (not damp) and correct size print media, and then click Print Test
Page in the Properties window of the print driver.
Disable the toner saving feature in the print driver.
See also:
• "Conserving Supplies" on page 333
®
print driver as an example.