System Settings - Fuji Xerox DocuPrint CM225FW User Manual

System Settings

Use the System Settings menu to configure a variety of printer features.
NOTE:
• The value marked by an asterisk (*) is the factory default setting.
• General
Purpose:
To configure general settings for the printer.
Power Saver Timer
Purpose:
To specify the time for transition to the power saver mode.
Values:
Low Power Timer
Sleep Timer
When you specify 5min for Low Power Timer, the printer enters the power saver mode 5 minutes after it finishes
a job. This uses much less energy, but requires more warm-up time for the printer. Specify 5min if your printer
shares an electrical circuit with room lighting and you notice lights flickering.
Select a high value if your printer is in constant use. In most circumstances, this keeps the printer ready to operate
with minimum warm-up time. Select a value between 5 and 30 minutes for Low Power Timer if you want a
balance between energy consumption and a shorter warm-up period.
The printer automatically returns to the standby mode from the power saver mode when it receives data from the
computer or remote fax machine. You can also change the status of the printer to the standby mode by pressing the
(Power Saver) button on the operator panel.
Date & Time
Purpose:
To specify the date and time formats.
Values:
Time Zone
Date
Format
Time
Format
Measurements
Purpose:
To specify the default measurement unit displayed after the numeric value on the operator panel.
Values:
Millimeters(mm)*
Inches(")
NOTE:
• The default for Measurements varies depending on other settings, such as Region and Original Size.
228 Using the Operator Panel Menus and Keypad
Specifies the time taken by the printer to enter the low power mode after it finishes
5min*
a job.
5–30min
Specifies the time taken by the printer to enter the sleep mode after it has entered
6min*
the low power mode.
1–6min
Sets the time zone.
Sets the date depending on the Format settings.
Sets the date format.
YYYY/MM/DD
DD/MM/YYYY*
MM/DD/YYYY
Sets the time.
Sets the time in 12-hour format.
12 Hour
Sets the time in 24-hour format.
24 Hour
Selects millimeter as the default measurement unit.
Selects inch as the default measurement unit.