Fuji Xerox DocuPrint CM225FW User Manual page 52

Wireless Connection
This section describes how to connect the printer to a computer via wireless network.
Confirm that the Ethernet cable has been disconnected from the printer and the status LED (Mobile) is blinking
before configuring the wireless connection.
IMPORTANT:
• The Wireless LAN feature is not available in all locations. Please check with your local Fuji Xerox representative for
availability of wireless in your location.
• If you are using a method other than Wi-Fi Protected Setup
get the SSID and security information from a system administrator before starting the setup procedure.
• Be sure to configure necessary settings on the wireless LAN access point (Registrar) or router before starting the printer
setup. For information on the access point or router settings, refer to the manual supplied with the product.
The specifications of wireless setting function are described below:
Item
Connectivity
Connectivity Standard
Bandwidth
Data Transfer Rate
Security
Certifications
Wi-Fi Protected Setup (WPS)
*1
WPA stands for Wi-Fi Protected Access
*2
WPS 2.0 compliant. WPS 2.0 works on access points with the following encryption types: Mixed Mode PSK, WPA-PSK-AES,
WPA2-PSK-AES, Open (No Security)
You can select a method to configure a wireless setting from the following:
Using the installer on the Software Pack CD-ROM (Windows Only) (Recommended for initial setup)
Refer to "Launching the FX Printer Installation Screen" on page 61.
WPS-PBC (Operator Panel Menu)
Refer to "WPS-PBC" on page 53.
*2
WPS-PIN
Refer to "WPS-PIN" on page 53.
Auto SSID Setup
Refer to "Auto SSID Setup" on page 54.
Manual SSID Setup
Refer to "Manual SSID Setup" on page 55.
*1
WPS-PBC (Wi-Fi Protected Setup-Push Button Configuration) is a method to authenticate and register devices required for
wireless configuration, by starting WPS-PBC on the printer with the operator panel menu, and then pressing the button provided on
the wireless LAN access point (Registrar) or router. This setting is available only when the access point supports WPS-PBC.
*2
WPS-PIN (Wi-Fi Protected Setup-Personal Identification Number) is a method to authenticate and register devices required for
wireless configuration, by entering PIN assignments in the printer and computer. This setting, performed through access point, is
available only when the access point of your wireless router supports WPS.
52 Printer Connection and Software Installation
™
Specification
Wireless
IEEE 802.11b/802.11g/802.11n compliant
2.4 GHz
IEEE 802.11b mode: 11, 5.5, 2, 1 Mbps
IEEE 802.11g mode: 54, 48, 36, 24, 18, 12, 9, 6 Mbps
IEEE 802.11n mode: 65 Mbps
64 (40-bit key)/128 (104-bit key) WEP, WPA
*1
(AES) (IEEE 802.1x attestation function of WPA 1x non-corresponds), Mixed
Mode PSK
®
Wi-Fi , Wi-Fi Direct
*2
Push Button Configuration (PBC), Personal Identification Number (PIN)
®
.
*1
(WPS) to configure your wireless network settings, be sure to
™
®
, WPA2.0 (Personal)
*1
-PSK (TKIP, AES) , WPA2
™
-PSK