Error & Status Messages On The Display; Error Messages - Ricoh SG 2100N User Manual

8. Troubleshooting
Error & Status Messages on the Display
This section explains what the messages that appear on the display mean and what to do when a
particular message appears.
Depending on the "Auto Continue" settings specified on the [System] menu, some of the following
messages might not appear. See page 145 "Using the [System] Menu"

Error Messages

Cannot recover error page(s) / FormFeed to print remaining
The machine confirmed that the error has been cleared and printing has resumed. However, some
page(s) did not print.
To continue printing, press the [Form Feed] key and print the missing page after the print job is finished.
To delete the print job, press the [Job Reset] key.
See page 264 "Cannot Recover Error Page".
Cannot use High Temp. / Power Off On
The temperature is abnormally high.
Check the installation area and relocate the machine. Alternatively, wait until the machine acclimates to
the room temperature.
See page 262 "Out of Printable Temperature Range".
Cannot use Low Temp. / Power Off On
The temperature is abnormally low.
Check the installation area and relocate the machine. Alternatively, wait until the machine acclimates to
the room temperature.
See page 262 "Out of Printable Temperature Range".
Change Setting Tray # / A4 (210×297) Plain Paper
The size of paper in the tray # (Tray 1, 2, 3, or the bypass tray) is different from the size specified.
Load the paper of the size specified in the paper tray, and then change the paper size in the paper input
menu accordingly.
Alternatively, press the [Form Feed] key, select a paper tray containing paper of the specified size, and
then print. To cancel the print job, press the [Job Reset] key.
See page 255 "Paper Size Mismatch/Paper Type Mismatch (Tray 1)", page 255 "Paper Size
Mismatch/Paper Type Mismatch (Tray 2/3)", page 255 "Paper Size Mismatch/Paper Type Mismatch
(Bypass Tray)".
246