Ricoh SG 2100N User Manual page 249

Change Settings Tray # / A4 (210×297) Plain Paper
The type of paper in the tray # (Tray 1, 2, 3, or the bypass tray) is different from the type specified.
Load the paper of the type specified in the paper tray, and then change the paper type in the paper
input menu accordingly.
Alternatively, press the [Form Feed] key, select a paper tray containing paper of the specified type, and
then print. To cancel the print job, press the [Job Reset] key.
See page 255 "Paper Size Mismatch/Paper Type Mismatch (Tray 1)", page 255 "Paper Size
Mismatch/Paper Type Mismatch (Tray 2/3)", page 255 "Paper Size Mismatch/Paper Type Mismatch
(Bypass Tray)".
Hardware Problem Ethernet Board
An error in the Ethernet port (ethernet board) network function has occurred.
Disconnect all cables, turn the machine off, and then turn it on again.
If the message reappears, contact your sales or service representative.
See page 263 "Network Interface Error".
Indepdnt.ink set
Indepdnt.ink set / Replace Ink Crtg
Indepdnt.ink set / Press # to continue
A non-genuine print cartridge was installed.
Use of non-genuine print cartridges or refilled print cartridges may reduce print quality or cause
malfunctions.
See page 278 "Recommended Consumables".
Ink Collector is not set / Set the Ink Collector Unit
The ink collector unit has not been installed correctly.
Reset the ink collector unit correctly.
See page 261 "Ink Collector Unit Not Detected".
Ink Collector Unit is full / Replace Ink Collector Unit
The ink collector unit is full.
Replace the ink collector unit.
See page 200 "Replacing an Ink Collector Unit".
Load Paper or Form Feed / A4 (210×297) Plain Paper
There is no paper trays that contain paper of the specified size and type.
Load paper of the specified size and type in a paper tray, and then specify the size and type in the
paper input menu accordingly.
Error & Status Messages on the Display
247