Set Temperature Correction; Various Setting On Outdoor Unit (Power Save, Cooking-Only, Etc.) - Toshiba RAS-M10PKVP-E Service Manual

Item Operation flow and applicable data, etc.
19. Set temperature Indoor Control P.C. Board (Factory Default)
correction
DB01
20. Various setting
on outdoor unit
(Power save,
Cooling-only,
Power save
etc.)
setup
Cooling-only
setup
Heating-only
setup
Caution:Set the switch before turning on the power supply.
L01
C03
T101
In HEAT Operation
Jumper wire setup
J804 J805
: With Jumper wire
: Cut Jumper wire
The following settings are available by DIP switch setup.
Function Setting position
SW802
1 2 3 4
Select current limit
Power save function
SW801
1 2 3 4
Cooling only setting
Heating only setting
1. Purpose
When the difference between the set temp. of
the remote controller and the room temp. is
wide due to the installation condition, etc, the
Jumper wire
J804
set temp. is corrected.
J805
(HEAT operation only)
J806
J807
2. Description
IC801 The set temp. received from the remote
controller is corrected.
The correct value from –2°C to +4°C is changed
J804
J805
by the jumper wire on P.C. board of the indoor
J806
microcomputer.
J807
HEAT
shift value
–2
+4
+2
← At shipment
0
Turn the switch to ON, when using the power save function.
SW802
ON
No.1
OFF
No.2
Current limit
When using the air conditioner as a cooling-only conditioner,
turn the switch to ON.
(If the heating mode is selected by remote controll, outdoor
unit will remain stop. If mixed with indoor unit cooling and
heating, outdoor unit performs cooling operation.)
ON
OFF
When using the air conditioner as a heating-only conditioner,
turn the switch to ON.
(If the cooling mode is selected by remote controll, outdoor
unit will remain stop. If mixed with indoor unit cooling and
heating, outdoor unit performs heating operation.)
– 74 –
Description
Control contents
ON ON OFF OFF
OFF ON ON OFF
11A 8.5A Full Full (Default)