Setting Temperature Correction Switch - Toshiba RAS-M10SMUV-E Service Manual

Item
16. Setting tem- 1. To improve Cooling/Heating effect
perature
When only poor cooling/heating effect is obtained due to installation place of the indoor unit or
correction
construction of the room, the detection temperature of cooling/heating can be changed.
switch
• Remove the cover of the electric parts box by taking off the mounting screws (3 positions)
and pushing the hooking section.
(The cover of the electric parts box remains hanged to the hinge.)
• There are the selector switches (SW01) on the P.C. board of the electric parts box.
The setting of the detection temperature can be changed by combining No.1 to No.4 switches
of the selector switches (SW01). Adjust the setting of the detection temperature according to
the following table.
No.1
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
<Setting at shipment>
Tel: 01823 665660
Heronhill - for all your Toshiba requirements
Operation flow and applicable data, etc.
No.2 No.3 No.4
OFF OFF OFF
OFF OFF OFF
ON OFF OFF
ON OFF OFF
OFF ON OFF
OFF ON OFF
ON ON OFF
ON ON OFF
OFF OFF ON
OFF OFF ON
ON OFF ON
ON OFF ON
OFF ON ON
OFF ON ON
ON ON ON
ON ON ON
– 36 –
www.heronhill.co.uk
COOL/DRY HEAT
(°C) (°C)
–2 –2
–2 +4
–2 +2
–2 0
+4 –2
+4 +4
+4 +2
+4 0
+2 –2
+2 +4
+2 +2
+2 0
0 –2
0 +4
0 +2
← Factory setting
0 0
ON
1
ON
Description
6H
2 3 4 SW01
TS ADJUST
ON
6H
SW02
Fax: 01823 665807