Removing The Main Parts - Toshiba RAS-M10PKVP-E Service Manual

10-6. Removing the Main Parts

Normally, the front panel, moving panel, and air flow
louvres do not need to be removed.
However, use the procedure below if removal of these
parts is necessary.
CAUTION
Before removing the front panel, moving panel, or air
flow louvres, be sure to stop operation of the air
conditioner and unplug the power supply.
10-6-1. Removing the Front Panel and Moving
Panel
1) Open the moving panel, and support the moving
panel by the panel support on the right side.
Moving
panel
Fig. 10-6-1
2) Remove the 4 set screws on the front panel.
Fig. 10-6-2
3) Insert your thumb into the air discharge bottom
section, and lift up the front panel bottom.
4) Close the moving panel to remove the clips on the
top side as shown below.
Push your finger down on the clip on the front panel
top, and lift up the panel back edge so that the clip
is released (5 locations).
Clip
Fig. 10-6-3
Panel support
Front panel
Clip
Clip
Clip
Clip
10-6-2. Removing the Moving Panel
1) Open the moving panel, and support the moving
panel by the panel support on the right side.
2) Remove the lead wire cover on the right side.
(1 screw)
Lead wire cover
Screw
3) After removing a screw of the left-side panel
stopper, slide the panel stopper downwards.
Panel stopper
Screw
4) Grasp both sides of the moving panel, return the
panel support to its original position, and push the
left-side arm inwards with your finger.
5) Pull out the moving panel towards the left side to
remove.
– 97 –
Fig. 10-6-4
Fig. 10-6-5
Fig. 10-6-6
Fig. 10-6-7