Toshiba RAS-M10PKVP-E Service Manual page 141

No. Part name
9 Compressor 1. Removal of defective compressor
assembly
1) Perform works of Detachment 1 of 1.
2) Recover the refrigerant gas from the outdoor unit.
3) Perform works of 2 , 3 and 4.
4) Remove the soundproof plate and TD sensor.
5) Take off fixing screw for the anchor board and the partition
plate. (ST1T Ø4 × 8, 1 pc.)
6) Take off fixing screws for the anchor board and the heat
exchanger. (ST1T Ø4 × 8, 2 pcs.)
7) Take off fixing screws for the anchor board and the valve
fixing plate. (ST1T Ø4 × 8, 2 pcs.)
8) Using a burner, remove the welded parts (discharge pipe,
suction pipe) connected to the compressor.
NOTE
Take care that the electrical control, sensors, compressor,
and etc. are not caught by flame. (Otherwise operation
trouble may occur.)
9) Pull out the refrigerating cycle upward.
NOTE
Pull out the refrigerating cycle by two or more persons.
10)Take off the compressor bolts (3 pcs.) which fix the
compressor to the compressor fixing plate.
11)Remove the compressor from the compressor fixing
plate.
NOTE
A compressor weighs approx. 15 kg.
Treat a compressor by two or more personals.
∗ Caution to assemble compressor
• Tighten the compressor bolt with 5 N•m (50 kgf•cm).
• Be sure not to turn lead wire of the coil.
• Take care there is no missing of sensor.
Procedure
– 141 –
Remarks
Partition plate
Compressor
Discharge pipe Discharge pipe Discharge pipe
(Take off) (Take off) (Take off)
Suction pipe Suction pipe Suction pipe
(Take off) (Take off) (Take off)
Compressor Compressor Compresso Compressor
∗ Mount the soundproof plate by passing
between the compressor and pipes and
between pipes and the partition plate in
order of upper, inner, outer and rear sides.
Soundproof plate Soundproof plate Soundproof plate
(Upper) (Upper) (Upper)
Soundproof plate Soundproof plate Soundproof plate Soundproof plate
(Outer) (Rear) (Rear) (Rear)
Soundproof plate Soundproof plate Soundproof plate
(Inner) (Inner) (Inner)
Valve
fixing plate