Toshiba RAS-M10PKVP-E Service Manual page 129

12-1-4. Microcomputer P.C. Board
1) Remove the electrical control cover screw.
2) Detach the metal electrical control cover.
3) Disconnect the connectors from the P.C. board.
4) Disconnect the solderless terminals from the P.C.
board.
5) Remove the P.C. board.
Electrical control cover detached
Screw
Electrical control
cover
Indoor P.C. board
Claw (2 locations)
Fig. 12-1-6
Claw
Sub-base
(2 locations)
12-1-5. Louver
1) Open the moving panel, and support it with the
panel support.
2) Open the vertical air flow louver.
3) Insert a flathead screwdriver into the gap of the
louver fixture on the right and left ends of the
vertical air flow louver, and turn in the counter-
clockwise direction to remove.
Removing the
louver fixture
(Left side)
4) After pushing in the right and left connector joints,
remove the vertical air flow louvres.
Remove the centre joint and bend the louver
downward.
Remove the right side joint first, and then, remove
the left side joint
Left side joint
– 129 –
Louver fixture
Horizontal air flow louvers
Air flow louver
Flathead screwdriver
Removing the
louver fixture
(Right side)
Fig. 12-1-7
Centre
Right side joint
joint
Fig. 12-1-8