How To Replace The Main Parts - Toshiba RAS-M10PKVP-E Service Manual

12-1. Indoor Unit
CHECK
WATCH OUT FOR FIRE
WEAR GLOVES
12-1-1. Removing the Front Panel and Moving Panel
1) Open the moving panel, and support the moving
panel by the panel support on the right side.
Moving panel
Fig. 12-1-1
2) Remove the four set screws on the front panel.
Fig. 12-1-2

12. How to Replace the Main Parts

WARNING
Since high voltages is applied to electrical parts, turn off the power without fail before
starting replacement work.
After repairs have been completed and the front panel and cabinet have been attached,
perform test run and check for smoke, unusual sound, and other abnormalities.
Failure to do so may cause fire or electric shock. Make sure that the cabinet is attached before
starting test run.
Perform the following when repairing the refrigeration cycle.
• Watch out for fire in the surrounding area. If a gas stove or other appliance is being used,
extinguish the flames before starting work. If the flames are not extinguished, they may
ignite oil mixed with the refrigerant gas and may cause fire or burn injury.
• Do not use welding equipment in an airtight room. Carbon monoxide poisoning may be
caused if the room is not well ventilated.
• Do not use welding equipment near flammable materials. Flames from the equipment may
cause the flammable materials to catch fire and may result in fire or burn injury.
CAUTION
Wear thick gloves such as cotton work gloves during repair work.
Failure to do so may cause injury by parts.
Panel support
Front panel
– 127 –
3) Insert your thumb into the air discharge bottom
section, and lift up the front panel bottom.
4) Close the moving panel to remove the clips on the
top side as shown below.
Push your finger down on the clip on the front panel
top, and lift up the panel back edge so that the clip
is released (5 locations).
Clip
Fig. 12-1-3
Clip
Clip
Clip
Clip