Toshiba RAS-M10PKVP-E Service Manual page 138

No. Part name
6 DI P.C. 7) Remove the earth wire of DI P.C. board. (Truss head B tight
board screw Ø4 × 6, 1 pc.).
(Continued) 8) Take off fixing screws for DI P.C. board. (Flange nut to fix
element Ø3 × 16, 7 pcs.: Pan head S tight screw to fix P.C.
board Ø3 × 20, 1 pc.)
9) Remove DI P.C. board. (3 supporters)
NOTE
Be careful that DI P.C. board is difficult to be taken out by
radiating grease for the heat sink.
10) Mount a new DI P.C. board.
NOTE
• Take note that the compressor lead V: CN201 (white) and
the reactor lead CN05, CN06 are correctly attached.
(For the compressor lead, the transparent sleeve is
attached to the circular terminal, and for the reactor lead,
the transparent sleeve is not attached to the circular
terminal.)
• Be sure not to forget to attach the Sub heat sink and also
the rediating sheet.
(If you apply a little amount of radiating grease beforehand
to the rear side of the insulation sheet, the attaching work
to the heat sink will become easy.)
Procedure
– 138 –
Remarks
[
Fixing screws
for element
(7 positions)
DI P.C. board
fixing screw
DI P.C. board Radiating grease
Sub heat sink Rediating sheet
Earth screw
Supporters
(3 positions)