Toshiba RAS-M10PKVP-E Service Manual page 134

No. Part name
2 Discharge 1. Detachment
port cabinet
1) Perform work of Detachment 1 of 1.
2) Take off screws for the discharge port cabinet and the
partition plate. (ST1T Ø4 × 8, 3 pcs.)
3) Take off screws for the discharge port cabinet and the
bottom plate. (Hexagonal screw Ø4 × 10, 2 pcs.)
4) Take off screws for the discharge port cabinet and the
motor base. (ST1T Ø4 × 8, 2 pcs.)
5) Take off screw for the discharge port cabinet and the heat
exchanger. (ST1T Ø4 × 8, 1 pc.)
6) Take off screws for the discharge port cabinet and the fin
guard. (Hexagonal screw Ø4 × 10, 2 pcs.)
3 Rear cabinet 1. Detachment
1) Perform work of Detachment 1 of 1.
2) Take off screw for the rear cabinet and the valve fixed
board. (Hexagonal screw Ø4 × 10, 2 pcs.)
3) Take off screw for the rear cabinet and the anchor board.
(Hexagonal screw Ø4 × 10, 1 pc.)
4) Take off screws for the rear cabinet and the heat
exchanger. (Hexagonal screw Ø4 × 10, 3 pcs.)
5) Remove the rear cabinet by shifting it obliquely backward
and upward.
Procedure
– 134 –
Remarks
Heat exchanger
Fin guard Motor base
Partition plate
Discharge port cabinet
Rear ca binet
Rear cabinet Rear cabinet
Inverter assembly Inverter assembly Inverter assembly
Rear cabinet Rear cabinet Rear cabinet