Self-Cleaning Function Release; Suction Temperature Correction - Toshiba ras-m16g3dv-e Service Manual

Item
• Self-Cleaning diagram
12. Self-Cleaning
function
Operation display
FCU fan
PRE, DEF display
Compressor
depend on presetting per room temperature.
CDU fan
depend on presetting per room temperature.
How to cancel Self-Cleaning function
13. Self-Cleaning
function
To cancel the Self-Cleaning function, proceed as follows:
release
• Press [TEMPORARY] button one time or use remote
control to turn on air conditioner. Display will show in
green color.
• Hold down the [TEMPORARY] button for more than 20
seconds. (The air conditioner will stop suddenly when
the [TEMPORARY] is pressed but keep holding it
continue.
• After holding about 20 seconds, the air conditioner will
beep 5 times without any blinking of display.
• The Self-Cleaning Operation had been cancelled.
How to set Self-Cleaning function
To set the Self-Cleaning function, proceed as follows.
• Press [TEMPORARY] button one time or use remote
control to turn on air conditioner. Display will show in
green color.
• Hold down the [TEMPORARY] button for more than
20 seconds. (The air conditioner will stop suddenly
when the [TEMPORARY] is pressed but keep holding
it continue.
• After holding about 20 seconds, the air conditioner will
beep 5 times and OPERATION display blinks 5
seconds.
• The Self-Cleaning function had been set.
If difference between room temperature and Ta sensor
14. Suction
temperature value is big, suction temperature shift by FC code setting
correction
is available, refer to 14-2 Appendix Function selection
setup.
Operation flow and applicable data, etc.
ON
ON
rpm is depend on presetting.
OFF
ON or OFF
ON or OFF
Cool mode or dry mode
operation more than 10 mins.
Turn off by remote controller or
OFF
ON
(Self-Cleaning fan speed)
ON
OFF
OFF
Self-Cleaning mode
operate 30 mins.
timer-off function.
– 35 –
Description
OFF
OFF
OFF
OFF
OFF
Automatically turn-off.
TEMPORARY
button
Operation time