Table of Contents
Advertisement
5. . . . Equipment
5-1. Eco Welding
The equipment is incorporates in Eco Welding features that are aimed at performing
the lower noise, the lower fuel consumption and the lower gas emission than
conventional models. When you turn the idle control switch to
engine speed will be adjusted automatically by load with green "ECO DRIVE"
indicator lamp turned on.
< Caution >
• The optimum engine speed will be adjusted
automatically while using welding output only.
• The engine speed will be set as rated speed while
using generating output only.
• The engine speed will be set as rated speed while
using
simultaneous
generating.
• The engine speed will be set automatically low speed at no load.
• Turn always the idle control switch to HIGH , when using motor with large capacity
or the load is incorporated with any magnet switch.
• When the load of less than 1A is connected to use, the feature does not function
sometimes. Therefore, turn the idle control switch to
• When welding operation or electric supply performs alternately or intermittently, turn
the idle control switch to
5-2. Welding Output Control
(1) CV/CC
The equipment incorporates CV (Constant Voltage) and CC (Constant Current)
characteristic feature.
Connecting a wire feeder and then turning the CC/CV Selector Switch to [CV-WIRE],
semi-automatic welding such as MIG, MAG, SS, etc. is available to perform.
Connecting the welding cables and then turning the CV/CC Selector Switch to
[CC-STICK, GOUGING], stick welding or arc gouging is available to perform.
When the CV/CC Selector Switch is positioned at [CV-WIRE], the current from the
terminals becomes Constant Voltage Characteristic. Therefore, Adjust the voltage by
the Output Control Dial.
When the CV/CC Selector Switch is positioned at [CC-STICK, GOUGING], the
current from the terminals is set as Constant Current Characteristic. Adjust current
by Output Control Dial.
(2) Welding Output Pre-Set
The equipment incorporates Welding Output Pre-Set feature.
When the CV/CC Selector Switch is positioned at [CV-WIRE], CV Output voltage
can be Pre-Set by the Output Control Dial
When the CV/CC Selector Switch is positioned at [CC-STICK, GOUGING], CC
Output current can be Pre-Set by the Output Control Dial.
<Caution>
The applicable remote controller with 9-Pin Connector has an Output control dial
which can be adjusted the output current in the remote area prior to the dial on
the machine.
(3) ARC CONTROL (for CC mode)
The equipment incorporates Arc Control feature.
Arc Control can be adjusted by turning the Arc Control Dial for suitable arc
performance. Stable (Mild) welding arc can be obtained with Arc Control Dial
use
of
welding
HIGH .
- 8 -
ECO , the optimum
ECO LAMP
and
HIGH .
IDOL CONTROL
SWITCH
Advertisement
Table of Contents
