Long-Term Storage - Shindaiwa DGW300MS Owner's And Operator's Manual

(7) Changing Coolant/Water
Replace
(Total Coolant/Water Capacity: about 3.0 L, including sub tank cap. 0.6 L)
RADIATOR
CAP
TOP PLATE
① Open the top plate.
② Remove the radiator cap.
③ Loosen the water drain plug.
④ After draining all the water, reinstall the water drain plug.
<Caution>
Change the packing, whenever changing oil.
Packing Part No.
⑤ Replace all the water in the sub tank.
⑥ Fill the coolant/water to the MAX level (to the upper edge of the inlet).
⑦ Reinstall the radiator cap.
⑧ Close the top plate.

12 Long-Term Storage

Danger : Electric Shock
Before performing any equipment check or maintenance, stop the engine, and
remove the engine key. A person performing the maintenance should always
keep the key.
Danger : Injuries
Close and lock all equipment doors during operating this equipment, to avoid
injuries by unintentional touching cooling fan and fan belt.
Caution : Injuries
Before performing any equipment check or maintenance, stop the engine, and
remove the engine key. A person performing the maintenance should always
keep the key.
Caution : Fire Burns
When checking engine, always stop the engine, and keep far away from fire.
Temperature around muffler and exhaust can get extremely high. Wait until the
engine cools down, before performing any checks.
If the generator/welder will not be used for more than two months, perform the
following maintenance and storage procedures.
① Remove the battery.
② Change the engine oil.
③ Drain fuel from the fuel tank, the Fuel Strainer and the Water Separator.
④ Clean all parts, cover the generator/welder, and keep it in the storage, away
from dust and humidity.
<Caution>
Recharge the removed battery once a month.
Every 2 years or 2000 hours
WATER INLET
6C090-58961 (Kubota)
- 28 -
RIGHT DOOR
SUB TANK
WATER DRAIN
PLUG