Monitor Lamp - Shindaiwa DGW300MS Owner's And Operator's Manual

5-7. Monitor Lamp

The equipment is incorporated in Monitoring function of WATER TEMP,BATTERY
CHARGING, OIL PRESSURE, OVERHEAT.
Under normal condition, when the starter
switch changes from [STOP]to [RUN],all the
lamps of BATTERY CHARGING, OIL
PRESSURE and OVERHEAT turn ON. When
the engine starts, all the lamps turn OFF. When
abnormality is detected on other than
OVERHEAT, the corresponding monitor lamp will flash, and the engine automatically
shutoff. When the automatic shutoff is engaged, turn the starter switch to [STOP]
position once, and then restart the engine. In the event the automatic shutoff is
engaged next time, check which lamp turns ON or OFF and point out where is the
abnormality.
(1) Coolant/Water Temperature Monitor Lamp
Danger: Injuries
Close and lock all equipment doors during operating this equipment, to avoid
injuries by unintentionally touching cooling fan and fan belt.
Caution: Burns
Do not open the radiator cap while operating this equipment or immediately
after stopping the equipment, to avoid sustaining burns from hot vapor.
Do not touch the engine and muffler during operation and immediately after
stopping the equipment, for the temperature can reach extremely high.
When the water temperature rises abnormally, the coolant/water temperature
monitor lamp will flash, and the automatic shutoff will be engaged.
When this occurs, check the coolant/water reservoir tank, and replenish if needed.
(Refer to 6-2. Checking coolant/water )
If the water level is normal, there may be a possibility of overloading. Always use the
equipment within the rated duty cycle and output power.
(2) Battery Charge Monitor Lamp
When the battery turns unable to be charged during operation, the battery charge
monitor lamp will flash and the automatic shutoff will be engaged. In the event this
occurs, consult with the authorized distributor or our engineering section.
<Caution>
The battery charge monitor cannot detect the degradation of the battery nor the
battery fluid level. Check the battery fluid level periodically.
(Refer to 6-5. Checking Battery )
(3) Oil Pressure Monitor Lamp
Danger : Injuries
Close and lock all equipment doors during operating this equipment, to avoid
injuries by unintentionally touching cooling fan and fan belt.
Caution : Burns
Do not touch the engine and muffler during operation and immediately after
stopping the equipment, for the temperature can reach extremely high.
When checking engine oil, always stop the engine, and wait until the engine
cools down. If you open either the oil gauge or the oil filter cap during
operation, hot oil may cause some injury.
WATER
TEMP
BATTERY
CHARGE
- 11 -
OIL PRESSURE
OVERHEAT