Checking And Maintenance - Shindaiwa DGW300MS Owner's And Operator's Manual

11 Checking and Maintenance

Danger : Electric Shock Injuries
Before performing any equipment check or maintenance, stop the engine, and
remove engine key. A person performing the maintenance should always keep
the key.
Close all doors and place locks during operating this equipment, to avoid
injuries by unintentional touching cooling fan and fan belt.
Caution: Fire Burns
Keep the equipment far away from fire.
When checking engine, always stop the engine, and keep away from fire. Wait
until the engine cools down, before performing any checks.
Do not open the radiator cap while operating this equipment or immediately
after stopping the equipment, to avoid sustaining burns from hot vapor.
Do not open the side door during operation and immediately after stopping
the equipment, because some parts/components (flexible tube, resistors, etc.)
can reach very high temperature inside the equipment.
Caution : Injuries to eyes and skin
Battery fluid contains diluted sulfuric acid. Avoid contact with eyes, skin or on
clothing. If the acid comes in contact, especially with eyes, flush with a lot of
water, and contact your physician immediately.
Caution : Explosion
Do not use the equipment or charge the battery, in the case the battery fluid
level is lower than the LOWER level.
Battery may emit some combustible gas, so keep it away from fire and sparks.
To optimize the use of this generator/welder, we recommend the periodical
equipment checks and maintenance based on the following matrix.
Use the hour meter as a guide for the operating time.
<Caution>
The authorized technicians should perform all checking and maintenance work,
except for the pre-startup checks.
Request for the maintenance item with ● mark to the authorized distributor or
our engineering section.
Always use our genuine parts of replacement.
When draining waste fluid from the equipment, catch it by tray.
When disposing of oil, fuel, coolant (LLC), fuel filter, battery and /or other harmful
disposal, please follow the international/federal regulations.
Please do not dispose the harmful items or waste fluid to the ground to a river,
pond, and ocean to keep our environment clean and neat.
Check to see if it is safe around the equipment before open the door.
Close all doors and place locks, if you leave from the equipment for a while.
Checking Items
1 Check and Supply Fuel
Check and Supply
2
Engine Oil
3 Engine Oil Change
4 Oil Filter Change
Startup
Every
At
Check
100
50hrs
hrs
○
○
nd
2 or
st
1
after
○ ○
st
1
○
- 24 -
Checking Time
Every Every Every
200 400 1000
hrs hrs hrs
nd
2 or
after
○
Every
2000
hrs