Auto Idle Feature - Shindaiwa DGW300MS Owner's And Operator's Manual

(2) Operation Check
Before operating the equipment, check always if the device can work duly as
shown in the following procedure.
① Start engine after turning the Idle Control
Switch to [HIGH].
② Turn (Push-up) the ELCB (lever) to ON
position.
③ Push the test button(Gray color) in the
ELCB. While test button is pressed,
the ELCB indicator (White) must be popped up and the lever positions will be
moved in between [ON] and [OFF].
④ Turn (Push-down) the ELCB (lever) to OFF position.
Return the ELCB (lever) to [ON] position.
⑤
(The ELCB indicator (white) will be returns to original position)
⑥ Restore the switch to STOP once, when starting the engine.
In the event you cannot complete all steps in the above procedure to the end, the
device is out of order. Consult with our authorized distributor or service dealers.
(3) The Earth Leakage Relay has activated
Caution: Electric Shock/Injuries
Be sure to disconnect all the loads to the equipment when turning the ELCB ON
again, after the earth leakage relay has activated.
When the earth leakage relay has activated, the ELCB indicator button (White)
popped up and the ELCB (lever) positions has moved to the position in between
[ON] and [OFF]. In the case, stop the engine promptly and find the leakage point to
repair. After repairing leakage point(s), reset the ELCB by following procedure.
Push the ELCB lever down to [OFF].
①
Then the ELCB lever will be able to be [ON] position.
②
<Caution>
When the ELCB has tripped to the middle but the indicator button is not popped
up simultaneously, the cause to have tripped is OVER-LOAD.
Restore as per the procedures No. 9-3 Operation.

5-9. Auto Idle Feature

The Auto Idle feature is to set the engine speed low automatically (in about 8
seconds) for the purpose of reducing noise and fuel consumption, whenever no
welding operation or electric supply is performed.
In the case of using the Auto Idle feature, turn the Idle Control Switch to [AUTO].
By the condition, the engine automatically moves to high speed, whenever welding
operation or electric supply starts.
Caution : Damage to the equipment or other properties
Turn always the Idle Control Switch to [HIGH], when the load is incorporated
with any magnet switch.
<Caution>
When the load of less than 0.5A is connected to use, the Auto Idle feature does
not function sometimes. Therefore, turn the switch to [HIGH].
When welding operation or electric supply performs alternately or intermittently,
turn the switch to [HIGH].
- 13 -
ELCB
INDICATOR
TEST
BUTTON
ELCB
(MAIN
BRAKER)