Equipment; Three-Phase And Single-Phase Simultaneous Output; Available Output Monitor; Spill Containment - Shindaiwa DGK45F Owner's And Operator's Manual

5.

Equipment

5-1. Three-phase and Single-phase simultaneous Output

This generator is capable of generating three-phase and single-phase three-wire output
simultaneously. (Three-phase output terminal and single-phase three-wire output terminal are
equipped individually.)
Neither switching operation of output nor switching operation of wiring is needed.
Three-Phase and Single-Phase Three-Wire Output Terminal
L1
< Note >
 Refer to section "7-2. Connecting Load Cables" for Load Connections.
 If using three-phase output simultaneously with a single-phase three-wire type output, use
in a range where the total current does not exceed the rated current.

5-2. Available Output Monitor

The available generated output for each output power source is displayed digitally. You can
use the display selector switch to change the display in the following order: three-phase,
single-phase three-wire U-W output, and single-phase three-wire U-N output, and
single-phase three-wire W-N output. Output of three-phase is always displayed when the
engine is started.
< Note >
 Consider the digitally displayed available output as an
approximate estimate. Be sure to thoroughly consider the
displayed value and the used load capacity when using a load
such as a motor with large starting capacity.
 The displayed output capacity might not be correct values if
using a four-wire connection (single-phase using the N
terminal) for a three-phase output power source. Connect to a
single-phase/three-line type power source if using a
single-phase power source.
 If "- -" is displayed for the available output, it means that usage
has exceeded the rated capacity. Immediately stop the equipment being used and reduce the
load capacity of the equipment.

5-3. Spill Containment

WARNING : INJURY
 Do not open the check door during operation. Be careful of pinching or
catching of moving parts such as the cooling fan and fan belt.
 Always be sure to stop the engine and remove the starter key when
performing inspection or maintenance.
L2 L3 N GROUND
10
U W
Display Selector Switch