Shindaiwa DGW300MS Owner's And Operator's Manual page 33

1. Weld Terminals Switch is
2. Operation Mode Selector
No Welding Output
3. Exceeding Duty Cycle
4. Malfunction of the Operation
1. Wrong Output Control Dial
2. Arc Control Dial is set to
3. Improper connection of cables
Welding Arc is
4. Improper Cable Diameter
weak
5. Improper connection to the
6. Simultaneous Use of Welding
7. Engine output is down
1. Wrong Output Control Dial
Excessive Welding 2. Arc Control Dial is set to
Arc
3. CV/CC Selector Switch is
Unable to weld 1. [OTHERS] mode is selected
the Cellulose rods
1. Wire feeder coupler is not
2. Circuit protector is activated
Unable to operate
3. Improper power input for the
the wire feeder
properly
4. [CC] mode is selected
Mode selector 1. Use of Welding or Generating
switch can not be
selected
1. The breaker (MAIN or 1-P)
No AC Output 2. Operation Mode Selector
1. The rated current of the load
AC Output is
weak 2. Use of Welding and
Unable to activate 1. Welding cables short circuit
the AUTO IDLE 2. The power consumption of the
mode
selected incorrectly as
[REMOTE CONTROL]
Switch is selected incorrectly as
[GEN ONLY]
(The warning lamp is blinking)
Mode Selector Switch
position
negative( ) side for CC mode
base material
and Generating
position
positive( ) side for CC mode
selected for [CC] Mode
for rod selection
connected properly
wire feeder
incorrectly
positions to [OFF]
Switch is selected incorrectly as
[WELDER ONLY]
exceeds the rated output
Generating
load is 0.5A or below
- 30 -
1. Turn to [WELD TERMINALS ON]
2. Turn to [WELDER ONLY] or
[GEN.WELDER] for welding
function
3. Stop the operation until the
equipment cools down (the lamp
to OFF)
4. Repair
1. Turn the dial clockwise
2. Turn the Arc Control Dial
clockwise to positive( ) side
3. Connect securely
4. Replace the cables based on
the Welding Cable Selection
5. Connect securely
6. Stop using AC Power output
7. Keep duty cycle
1. Turn the dial counterclockwise
2. Turn the dial counterclockwise
to negative( ) side
3. Turn to [CV] mode
1.Select [CELLULOSE] mode
1. Confirm the coupler for proper
connection
2. Reset the circuit protector
3. Select the correct power input
42V/115V for designated wire
feeder
4.Select the [CV] mode properly
1. Stop using the machine load
and keep idling for selecting
the switches
1. Turn to [ON]
2. Turn to [GEN.WELDER] or
[GEN.ONLY]
1. Adjust according to
OUTPUT LIMITATION
2.Stop Welding
1. Repair the short circuit
2. Set the Idol Control to [HIGH]
mode