Table of Contents
Advertisement
5. Equipment
5-1. Idle Control
The equipment includes an idle control function. You
can use the idle control switch to select an engine
speed setting of "AUTO","HIGH".
(1) Auto Idle
The equipment includes an auto idle function in order to reduce noise, save fuel, and
reduce exhaust gas emission.
You can set the idle control switch to "AUTO" so that the engine operates at low
speed when not welding or using the equipment as a power source.
When you start to weld or use as an AC power source, the engine automatically
increases to high speed. When in a no-load condition, the engine automatically
returns to low speed after approximately eight seconds of high-speed operation.
<Note>
• Set the idle control switch to "HIGH" if using a high capacity motor, precision
instruments or AC load with an attached magnetic switch.
• Set the idle control switch to "HIGH" if using as an AC power source of a device
of 0.5 A or less because the engine might not reach a high speed as speed
control does not operate at that level.
(2) High Idle
You can set the idle control switch to "HIGH" to maintain the engine constantly at
high speed.
5-2. Weld Output Control
(1) Weld Output Pre-Set
The equipment includes a weld output pre-set
function.
You can pre-set the output current using the output
control dial. Welding current at the dial position. (The
Values shown in the table are for reference only)
Adjust the current amperage by the weld output control dial, per the table below.
MIN
1
60
90
The values shown in the table are for reference only. The length and the ambient
temperature affect the value.
(2) Arc Control
The equipment includes an arc control function that
adjusts the arc strength.
You can adjust the setting of the arc control dial of the
short-circuit current of the weld output.
Welding Current at the dial position(A)
2
3
190
290
- 9 -
Idle Control Switch
Weld Output Control Dial
Arc Control Dial
4
5
390
490
Weaker
Arc Control Dial
MAX
500
Stronger
Advertisement
Table of Contents
