Shindaiwa DGW300MS Owner's And Operator's Manual page 30

(4) Clean/Change Fuel Strainer
Clean
Replace
① Turn the fuel lever to [CLOSE].
② Unscrew the retainer ring counterclockwise,
and remove the cup and the filter element.
③ Discard any dust or water inside the cup,
and clean the filter element by blowing
compressed air, or replace if necessary.
④ Reassemble it back.
<Caution>
Be sure to check for any contaminants on the
packing, whenever reinstalling the cup.
Turn the fuel lever to [OPEN] after assembling,
and check for any leak. Having confirmed no
leak without fail, turn the fuel lever to [CLOSE].
Element Part No.
(5) Drain Water from Water Separator
Drain
When the Float (red) is coming up to Drain Water Drain Line, drain the water.
① Turn the fuel lever to[CLOSE].
② Unscrew the retainer ring counterclockwise, and remove the cup and the
gauze filter.
③ Dispose water or dirt inside the cup.
When dirt is adhered to the gauze filter, clean the filter by compressed air.
④ Reassemble it back.
RIGHT DOOR
WATER
SEPARATOR
<Caution>
Be sure to check for any contaminants on the packing, whenever reinstalling the
cup.
Turn the fuel to [OPEN] after assembling, and check for any leak. Having
confirmed no leak without fail, turn the fuel lever to [CLOSE].
(6) Drain Water from Fuel Tank
Drain Water
① Unscrew the fuel drain plug.
② Reinstall the drain plug, after draining
water completely
<Caution>
Change the packing, whenever changing oil.
Packing Part No.
After reinstalling the fuel drain plug tightly, keep the engine drive for a while to
check no fuel leakage and then stop the engine.
st
1 50 hours and Every 100 hours afterwards
Every 400 hours
16271-43561 (Kubota)
Every 400 hours
Every 200 hours
6C090-58961 (Kubota)
- 27 -
RIGHT
DOOR
FUEL
STRAINER
RETAINER
RING
ELEMENT
FUEL LEVER
RETAINER
RING
GAUZE
FILTER
DRAIN WATER
LINE
FUEL DRAIN PLUG
FUEL LEVER
CLOSE
OPEN
CUP
CLOSE
OPEN
CUP
FLOAT(RED)