Engine does not
1. Stop Solenoid malfunction
stop
1. Overloaded use
Excessive Black
smoke exhaust
from muffler
13-2. Error Code Display
Inspect the following items accordingly when the Error Codes are displayed on
the control panel.
Error No.
Possible Causes
E01
Alternator and/or
Control parts
[OVER HEAT]
Overheat
Monitor Lamp
is also blinking
Welding output
E03
Short Circuit
Incorrect
Welding Mode
E04
Selector
Incorrect
Operation Mode
E05
Selector
Control parts
06
Malfunction
Digital Meter (Error Code Display)
<Caution>
The authorized technicians should perform all inspection and maintenance work,
except for the pre-startup checks.
Check to see if it is safe around the equipment before attempt to open the door.
Close and lock all equipment doors , if you leave from the equipment.
1. Turn the fuel lever to [CLOSE]
1. Operate the machine within the
Corrective Actions
Turn the Idle Control Switch to [AUTO] and cool down
the unit with no-load operation until [OVERHEAT]
Monitor Lamp blinking will be stopped.
Stop the engine after the [OVERHEAT] Monitor Lamp
blinking will be stopped, then restart the engine.
O perate the unit properly based on the operation
※
manual to avoid overload, over-duty cycle, unclosed
door, and / or intake/exhaust clogging etc.
Shut off the engine immediately and confirm if there is
short circuit on the welding output.
Start the engine after resolving the troubled area for
recovery.
Shut off the engine immediately and resolve the
malfunction components.
C onsult your dealer for necessary inspection
※
Shut off the engine immediately and resolve the
malfunction components.
C onsult your dealer for necessary inspection
※
Shut off the engine immediately and resolve the
malfunction components.
C onsult your dealer for necessary inspection
※
- 31 -
to stop and repair
rated output