Table of Contents
Advertisement
5-10. Emergency Stop Switch
The Emergency Stop Switch is used to stop the engine in
emergency. By pushing the switch, the engine stops.
Be sure to restore the Starter Switch to [STOP] and reset
the Emergency Stop Switch, turning clockwise after using
the switch.
5-11. Battery Isolator
When turning the Battery Isolator Switch to
[OFF] position, the engine electric circuit
does not get battery power.
<Caution>
Do not turn the Battery Isolator position
while in operation, it may cause the
serious damage on the unit.
6. . . . Initialization and Pre-operation check
Danger : Electric Shock Injuries
Before performing any inspection or maintenance, always stop the engine, and
remove engine key. A person performing the maintenance should always keep
the key.
Close and lock all equipment doors during operating this equipment, to avoid
injuries by unintentional touching cooling fan and fan belt.
Caution : Fire Burns Injuries
When checking engine, always stop the engine, and keep away from fire. Wait
until the engine cools down, before performing any inspection.
6-1. Checking Engine Oil
When checking for engine oil, be sure to
keep the equipment leveled, and insert the
oil gauge all the way in. Prior to starting
the equipment, make sure to fill the engine
oil to the UPPER line through the oil inlet.
<Caution>
If the equipment is not leveled, it is
difficult to check the accurate oil level.
Do not overfill (over UPPER line) the engine oil.
The excessive Amount of engine oil may damage
the engine (inside the cylinders)
Selecting proper engine oil
<Caution>
Use the API class CD or higher.
Viscosity and Temperature
Temperature
Viscosity
Over +20 ℃
+10 +20 ℃
SAE30
- 14 -
OFF position
RIGHT
DOOR
OIL
GAUGE
-10 +40 ℃
SAE20
SAE10W/30
STOP
RESET
ON position
OIL INLET
OIL PLUG
OIL DRAIN
PLUG
UPPER LEVEL
EFFECTIVE
LOWER LEVEL
Advertisement
Table of Contents
