Shindaiwa DGW300MS Owner's And Operator's Manual page 29

<Caution>
Refer to 6-1. Checking Engine Oil to select engine oil.
Change the packing, whenever changing oil.
Packing No.
After reinstalling the oil drain plug tightly, keep the engine drive for a while to
check no engine oil leakage and then stop the engine.
(2) Oil Filter Change
First Time
nd
2 or after
① Drain the engine oil completely, as described
in 11 (1) Oil Change .
② Loosen and remove the oil filter, using an oil
filter wrench.
③ Smear a little engine oil on the rubber
gasket of a new filter.
④ Screw the new filter into place and tighten it
by hand until the gasket contact the seat.
Then, give it additional 1.1/4 Turn to seat
the filter, using an oil filter wrench.
⑤ Supply oil and install the filler cap.
<Caution>
If an oil filter wrench is not available, contact our authorized distributor or service
dealers .
Oil Filter Part No.
(3) Clean/Change Air Filter Element
Clean
Replace
① Loosen the wing bolt to remove the cleaner cap.
② Remove the air element.
③ Clean or replace the air cleaner element.
<The element is adhered with dried contaminants>
Blow up by compressed air from inside the element.
<The element is adhered with carbon or oil>
Replace to a new one.
④ Reinstall them in reverse order.
<Caution>
Clean more frequently, if it is used in dusty environment.
Element Part No.
6C090-58961 (Kubota)
50 hour mark
Every 200 hours
15241-32090 (Kubota)
st
1 50 hours and Every 100 hours afterwards
Every 400 hours
RIGHT DOOR
AIR CLEANER
67980-82632 (Kubota)
- 26 -
CLEANER CAP
AIR CLEANER
WING BOLT
ELEMENT
LEFT
DOOR
OIL
FILTER