Shindaiwa DGW300MS Owner's And Operator's Manual page 6

Caution : Explosion
Do not use the equipment or charge the battery, in the case the battery fluid
level is below the LOWER level.
Battery may emit some combustible gas, so keep it away from fire and sparks.
Caution : Fire
The equipment uses Diesel as a fuel. When inspecting the equipment or
refueling, always stop the engine and keep away from fire. Always wait until the
engine cools down before refueling.
Always wipe away any drip of Diesel fuel or lubrication oil. Do not use this
equipment when a leak is found. Repair the equipment before use.
Temperature around muffler and exhaust can get extremely high. Keep any
inflammable items (such as fuel, gas, paint, etc.) away from the equipment.
Keep any flammable items and combustible items away from the welding area,
as welding causes hot spatters.
Always operate this equipment on flat surface and, at least 1 meter away from
any objects (wall, box, etc.).
Do not connect AC output to any indoor wiring.
Always wait until the equipment cools down, before placing any covering
materials for storage.
Caution : Burns
Do not open the radiator cap while operating this equipment or immediately
after stopping the equipment, to avoid sustaining burns from hot vapor.
Do not touch the engine and muffler during operation and immediately after
stopping the equipment, for the temperature could reach extremely high.
When checking engine oil or changing oil, always stop the engine, and wait until
the engine cools down. If you open either the oil gauge or the oil plug during
operation, hot oil may cause some injury.
Be sure to wear leather gloves, apron, shoe covers, eye protection
glasses/mask, safety shoes, safety cap, and long sleeve shirts, to protect from
spatters.
Do not open the side door during operation and immediately after stopping the
equipment, because some parts/components (flexible tube, resistors, etc.) can
reach very high temperature inside the equipment.
Caution : Injuries
Always utilize lifting lug and proper slings to lift the equipment then move the
equipment carefully .
When lifting the equipment, always wear helmet, safety shoes, and gloves.
Never enter the position under the equipment.
When carrying the equipment by trucks, fix it strongly to keep the equipment
from sliding.
Always place the equipment on a flat and stable surface, to keep the equipment
from sliding.
When starting the engine, turn off the connected equipment and set the circuit
breaker to OFF position.
Do not move the equipment during operation.
When performing equipment check and maintenance, always stop the engine.
Do not operate the equipment, if the equipment is being modified or if the parts
are removed.
- 3 -