Engine Board Removal; Charge Roll Assembly Removal; Fuser Assembly Removal - Lexmark E32x Service Manual

4500–32x x

Engine Board Removal

1. Remove the toner cartridge.
2. Tilt the printer carefully to the rear so it is resting on the ASF. F.
3. Remove the four bottom cover screws.
4. Disconnect the cables.
5. Remove the four engine board screws.
6. Remove the engine board.

Charge Roll Assembly Removal

1. Remove the front cover. See
more information.
2. Remove the top cover. See
information.
3. Remove the left side cover. See
page 4-3
4. Remove two cooling fan screws.
5. Remove the toner cartridge.
6. Remove controller board cage. See
Removal" on page 4-4
7. Remove the two fuser top cover screws.
8. Remove fuser top cover.
9. Remove left and right charge roll assembly brackets.
Note: When reinstalling charge roll assembly brackets, ensure
brass spring is on the left and silver spring is on the right.
10. Remove charge roll assembly.

Fuser Assembly Removal

1. Tilt the printer carefully to the rear so it is resting on the ASF.
2. Remove the four bottom cover screws.
3. Disconnect J7 (THM) from engine card.
4. Reattach bottom cover and set printer upright.
5. Remove charge roll assembly. See
Removal" on page 4-6
6. Remove the two fuser mounting screws.
7. Disconnect the fuser wires.
8. Release the tabs on each end of fuser assembly and lift out.
4-6
Service Manual Manual
Assembly Removal
for more information.
THM) from engine card.
See "Front Cover" on page 4-2
"Top Cover" on page 4-2
"Left Side Cover" on
"Controller Board Cage
for more information.
See "Charge Roll Assembly
for more information.
for
for more
ASF.