Audio Jack Board - HP ElitePad 1000 G2 Maintenance And Service Manual

Audio jack board

Description
Audio jack board (includes audio jack and cable)
Before removing the audio jack board, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and
then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the display assembly (see
5. Remove the NFC antenna (see
Remove the audio jack board:
1. Disconnect the audio jack board cable (1) from the system board.
2. Remove the two Phillips PM1.3×2.0 screws (2) that secure the audio jack board to the bottom cover.
3. Remove the audio jack board (3) and cable.
Reverse this procedure to install the audio jack board.
46 Chapter 5 Removal and replacement procedures
Display assembly on page
NFC antenna on page 35).
Spare part number
747627-001
28).