Table of Contents
Advertisement
Chapter 10
Routed PPPoI
86
9
Select the Mode (On-Demand or Always On)
10
Fill in the idle time limit. If the connection is On-Demand, and the connection is
idle for this amount of time (i.e. no traffic), the connection shuts down.
The other values are automatically retrieved when the PPP connection is
established
.
You cannot enable Callback via the Web interface. For this, you must use
CLI. If you do not enable it, the SpeedTouch™ will establish the ISDN
connection over which the PPP connection is made.
Via CLI
Use the following command sequence to configure the ISDN dial-in connection via
CLI:
[isdn]=>ifconfig
intf
BODstart
callback
[isdn]=>ifconfig
intf = buisdn
[number] = 025292222
[mlppp] =
disabled
[mlppp] = disabled
[BODstart] = 40
[BODend] = 38
[mode] = dialout
[callback] =
disabled
[callback] = disabled
[group] = empty
:isdn ifconfig intf=buisdn mlppp=disabled callback=disabled
[isdn]=>:isdn ifconfig intf=buisdn mlppp=disabled callback=enabled
[isdn]=>saveall
[isdn]=>:ppp
[ppp]=>ifattach intf bu_isdn
[ppp]=>
[ppp]=>
number
BODend
group
enabled
enabled
mlppp
mode
E-DOC-CTC-20051017-0167 v1.0
Advertisement
Table of Contents
