Table of Contents
Advertisement
The Bridge interface
E-DOC-CTC-20051017-0167 v1.0
Proceed as follows to create, configure and attach/connect the bridge interface:
1
Create a new bridge interface with name BrETHoA_br.
=>eth bridge ifadd intf=BrEthoa_br
=>
2
Configure the new bridge interface with as destination the ATM interface
created above.
=>eth bridge ifconfig intf=BrEthoa_br dest=BrEthoa_atm
=>
3
The Bridged Ethernet interface is not yet connected. Connect the bridge
interface.
=>eth bridge ifattach intf=BrEthoa_br
=>
4
Execute saveall at the prompt to save this configuration.
=>saveall
=>
For a complete description of all CLI commands, see the
SpeedTouch™ CLI Reference Guide.
Chapter 2
Bridged Ethernet
15
Advertisement
Table of Contents
