Table of Contents
Advertisement
2.1 SpeedTouch™ Bridged Ethernet Configuration
Preparatory steps for
using Bridged Ethernet
Interface road map
Configuration procedure
E-DOC-CTC-20051017-0167 v1.0
To be able to configure the SpeedTouch™ successfully for the Bridged Ethernet
Packet Service, the following information must be available:
The VPI/VCI value of the Virtual Channel on which the ETHoA connection
service is enabled.
The encapsulation method (in most, if not all cases LLC/SNAP).
The IP configuration of the local host.
The figure below shows the interfaces which have to be configured for Bridged
ETHoA.
ARP
IPoE /
PPPoE
IPoEoA
Ethernet Interface(s)
VLAN
Bridge
Physical Ports
(Eth, USB, WLAN, BT...)
Interfaces connected with red arrows are by default created and connected.
Interfaces connected with blue arrows need to be created and connected.
The colours used correspond with the colours used in the
This procedure will guide you via the CLI through the configuration process.
LoopBack
IP Forwarding
IP Interface(s)
PPP
PPPoE RELAY
PPPoA
EthoA
ATM Interface(s)
ATM Bundle
ATM VP/VC
(Over DSL / ATM-F)
Chapter 2
Bridged Ethernet
iARP
Multilink
IPoA
PPP
ISDN
" Protocol
stack".
13
Advertisement
Table of Contents
