Table of Contents
Advertisement
Chapter 5
Routed PPPoE
Interface road map
Configuration scenarios
40
The figure below shows the interfaces which have to be configured for Routed
PPPoE.
ARP
IPoE /
PPPoE
IPoEoA
Ethernet Interface(s)
VLAN
Bridge
Physical Ports
(Eth, USB, WLAN, BT...)
Interfaces connected with red arrows are by default created and connected.
Interfaces connected with blue arrows need to be created and connected.
The colours used correspond with the colours used in the
Two popular TCP/IP scenarios exist for Routed PPPoE implementations (see
section" Routed PPPoE – TCP/IP Configuration" on page
example of the configuration procedure for both scenarios:
1
Routed PPPoE with NAPT
2
Routed PPPoE with DHCP Spoofing
LoopBack
IP Forwarding
IP Interface(s)
PPP
PPPoE RELAY
PPPoA
EthoA
ATM Interface(s)
ATM Bundle
ATM VP/VC
(Over DSL / ATM-F)
iARP
Multilink
IPoA
PPP
ISDN
" Protocol
stack".
38). This section gives an
E-DOC-CTC-20051017-0167 v1.0
Advertisement
Table of Contents
