Table of Contents
Advertisement
Chapter 6
PPPoE Relay
The ATM interface
The Ethernet interface
54
Proceed as follows to create an ATM phonebook and the ATM interface.
1
Add a new ATM Phonebook entry with the correct VPI/VCI values.
=>atm phonebook add name=Relay_ph addr=8.35
=>
If another phonebook entry with the same VPI/VCI already exists, you
will have to delete this entry first.
2
Add a new ATM interface with name Relay_atm.
=>atm ifadd intf=Relay_atm
=>
3
Configure the new ATM interface with as destination the phonebook entry
created above. Define also the upper layer interface type.
=>atm ifconfig intf=Relay_atm dest=Relay_ph ulp=mac
=>
By default, the encapsulation method will be LLC/SNAP.
4
Connect the ATM interface to the phonebook entry.
=>atm ifattach intf=Relay_atm
=>
Proceed as follows to create, configure and attach/connect the Ethernet interface:
1
Add a new Ethernet interface.
=>eth ifadd intf=Relay_eth
=>
2
Configure the new Ethernet interface with as destination the ATM interface
created above.
=>eth ifconfig intf=Relay_eth dest=Relay_atm
=>
3
Connect the ETH interface.
=>eth ifattach intf=Relay_eth
=>
E-DOC-CTC-20051017-0167 v1.0
Advertisement
Table of Contents
