Table of Contents
Advertisement
7.1 SpeedTouch™ Routed PPP
Preparatory steps for
using Routed PPPoA
Interface road map
E-DOC-CTC-20051017-0167 v1.0
The following information must be available to successfully configure a Routed
PPPoA interface on the SpeedTouch™:
The VPI/VCI value of the Virtual Channel on which the PPPoA connection
service is enabled.
The encapsulation method (normally VC-MUX).
The Routed PPPoA interface's IP configuration, either via single IP address, or
via IPCP subnet masking. The latter configuration requires all local nodes to be
configured for DHCP and the SpeedTouch™ DHCP server being active.
The user name and password for the ISP account.
The figure below shows the interfaces which have to be configured for Routed
PPPoA.
ARP
IPoE /
PPPoE
IPoEoA
Ethernet Interface(s)
VLAN
Bridge
Physical Ports
(Eth, USB, WLAN, BT...)
A Configuration
O
LoopBack
IP Forwarding
IP Interface(s)
PPP
PPPoE RELAY
PPPoA
EthoA
ATM Interface(s)
ATM Bundle
ATM VP/VC
(Over DSL / ATM-F)
Chapter 7
Routed PPPoA
iARP
Multilink
IPoA
PPP
ISDN
61
Advertisement
Table of Contents
