Routed Ipoa With Napt - THOMSON SpeedTouch Configuration Manual

Chapter 9
Routed IPoA

9.1.1 Routed IPoA with NAPT

Configuration procedure
The ATM interface
78
Proceed as follows to configure a Routed IPoA entry:
1
Create, configure and attach/connect the ATM interface.
2
Create, configure and attach/connect the IP interface.
3
Assign an IP address to the IP interface.
4
Check your configuration.
Proceed as follows to create an ATM phonebook and the ATM interface.
1
Add a new ATM Phonebook entry with the correct VPI/VCI values.
=>atm phonebook add name=RtIPoA_ph addr=8.35
=>
If another phonebook entry with the same VPI/VCI already exists, you
will have to delete this entry first.
2
Add a new ATM interface with name RtIPoA_atm.
=>atm ifadd intf=RtIPoA_atm
=>
3
Configure the new ATM interface with as destination the phonebook entry
created above. Define also the upper layer interface type.
=>atm ifconfig intf=RtIPoA_atm dest=RtIPoA_ph ulp=ip
=>
By default, the encapsulation method will be LLC/SNAP.
4
Connect the ATM interface to the phonebook entry.
=>atm ifattach intf=RtIPoA_atm
=>
E-DOC-CTC-20051017-0167 v1.0